 |
 |
 |
 |
|
One
Piece, 22g, Heavy Duty Switch Harness, $19.95
This Double Pole switch is similar to the switch
harness above except that rather than having a separate connector for
charging, a charging receptacle is built into the body of the switch itself. This makes for a very neat, single hole installation in the side of
your aircraft. It is available with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.
|
 |
|
|
 |
|
Heavy
Duty "Miracle" Switch Harness, $39.95
The electronic Miracle Switch
replaces the regular mechanical switch in your aircraft and includes a
built in 6V regulator. Under normal conditions, the switch functions
like a regular switch. However, if the switch fails, the current
continues to flow and you don't crash. In the unlikely event of this
happening, the only way to turn off the system is to disconnect the Rx
battery pack from the switch harness.
Key
Features:
- Built in 6V
regulator
- Input
voltage: 4V - 7V
- Output
Voltage: 6V
- Current: 5
Amp continues, 10 Amp Peak
- Idle Current:
3ma max
- Weight only
0.7oz
It is available with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.
|
 |
|
|
 |
|
Heavy
Duty Servo Extensions
The worst thing you can do in a Giant Scale
aircraft is use inadequate wiring. Because of the higher flight loads and
higher current drain from the battery pack, any extending of the leads
going to the servos is critical. Heavy Duty servo extensions are available
with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.If you need to extend the lead between the
battery pack and the switch harness, we recommend that rather than using
extensions, you request that we wire a pack for you with 18g wire of the
required length.
|
 |
|
|
 |
|
22g,
Heavy Duty "Y" Harnesses
These 22g, Heavy Duty "Y" harnesses
are perfect for connecting two servos to a single channel of your
receiver. They are used for split elevator, split flap, and twin engine
installations. They are available with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.
|
|
|
|
 |
|
22g,
Heavy Duty Double Extensions, $9.95
These 22g, Heavy Duty Double Extensions are
very similar to "Y" harnesses above except that there's no "Y". Instead of
three wire legs that are connected in the middle, the Double Extension is a
single lead with a single male lead at one end (which for instance will plug
into a receiver) and a double female receptacle at the other end into which
you can plug two servo leads.
Heavy
Duty Double Extensions come in two lengths: 6" and 12".
They are available with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.
|
|
|
|
 |
|
Heavy
Duty Miracle "Y" Harness, $21.95
This reversing Y-Adapter is designed for Giant Scale aircraft with split
elevators, split flaps, or twin engines. It will reverse the direction of
rotation of one servo while not affecting the second servo.
The Miracle "Y" harness is available with your choice of
either a Universal connector compatible with JR, Hitec, and Airtronics-Z; or a Futaba J connector.
Please specify connector type when ordering.
|